SULFUR
(HOT POUR TYPE) :-
|
° |
INTRODUCTION:
This is a hot-pour, plasticized sulfur base compound,
mainly used with acid resisting bricks to protect floors,
pickling tanks, sumps etc. Sulfur is used with acid
resistant brick and tile to protect storage tanks, floors,
drains, sumps, pits, pickling tanks in steel & electro
plating industries, tube mills etc.
|
| ° |
PHYSICAL PROPERTIES:
| Color |
Black |
| Mix Ratio by wt. Sol to Powder |
HotMelt |
| Compressive Strength kg/cm2 |
275 |
| Flexural Strength kg/cm2 |
70 |
| Bond Strength kg/cm2 |
5 |
| Water Absorption |
1% |
| Max. Temp. |
90 C |
| Setting Time In Hours |
2 Hrs. |
|
| ° |
METHOD
OF APPICATION:
Break the sulfur bricks into very small pieces and place
in clean, dry heating pan. Start melting it with slow
heating and stir it while heating until you get free
flowing smooth liquid. Then pour between the joints
of acid resistance bricks/tiles. Avoid air pocketing
while filling the joints.
|
| ° |
CHEMICAL
RESISTANCE PROPERTIES::
Sulfur is recommended against non-oxidizing acids, diluted
oxidizing acids and acidic and neutral salts at recommended
temperature. It is not recommended for use against alkalis,
Hydrofluoric acid, fluoride salts etc. For this, 100
% carbon filled sulfur "C” is available.
|
| ° |
STORAGE & SAFETY:
Always keep sulfur away from direct heat and in dry
place. It can be stored like this, for unlimited period.
|
| ° |
PACKING:
Sulfur is supplied in 40 kgs (NET) bags.
|
| ° |
HEALTH & SAFETY:
It is advisable to wear protective wears at the time of
use of SULFUR and any other our products. rovide adequate
ventilation while melting. Handle with care when hot.
In case of inhalation of fumes, remove person to fresh
air. In case of contact with skin or eyes, contact a doctor
immediately. This information, given in good faith, is
based on results gained from experience and tests. However,
all recommendations or uggestions are made without guarantee
since the conditions of use are beyond our control. |
