DESCRIPTION: Epoxy
Screed is a solvent free highly filled three parts
flooring screed. When applied on concrete surface,
it gives a high strength flooring & tank lining,
capable to withstand extremly high loading, wear
and chemical resistance.
FEATURES: When used as flooring or tank lining screed
mortar:
- Forms seamless surface
- Very high mechanical strength
- Excellent chemical resistance
- Hygienic
- Dust free surface
- Hard wearing
- Anti-slip & anti-skid finish
USES
Epoxy Screed is highly recommended, for use, for
factory floor & workshop
Automobiles
Food & pharmaceuticals
Chemical & Engineering.
Beverages,
Textile & Pulp-Paper,
Electronic industries.
SPECIFICATION
|
Film
Thickness |
4-5 mm |
Coverage |
9-11
kg/cm /M (Approx)
|
| Application
|
Trowel
|
| Curing |
Initial-6-6-7
Hrs Full 7 days
|
| Finish |
Gloss |
| Mixing
Ratio |
As
directed on Packing |
| Colors |
Grey,
Green, Red, Black, White or as required |
|
SURFACE
PREPARATION : Successful performance
of Epoxy S/L or any other flooring system can
achieve only after proper surface preparation.
It is the prime requirement, that surface must
correctly prepared before application.
- New concrete or cementations surface must be
cured for 28 days.
- Surface must be free from any oils, grease, loose
particles, curing aid chemicals, previously applied
coating etc...
- Surface must be fully dry.
- For old surface all cracks, cavities should
be repaired with Epoxy mortar
- This is a very thin topping so can not level
any irregularities of levels of the original
sub-base. Therefore, it is most important to
make original surface in line & level, before
application of Epoxy Screed
APPLICATION
PRIMER COAT: Apply one coat
of Epoxy primer on properly prepared surface by
brush and allow it to dry.
SCREED APPLICATION: First mix
the resin part A, thoroughly with slow speed mixer
until uniform color is achieved. Then add curing
agent part B and mix again with mixer. After that,
add filler par C and mix with mixer until a homogeneous,
lumps free mass is achieved.
Then, place the mixed mortar evenly. Temp down with
beam laid across steel screeding rails of specific
height for desired thickness and finish with steel
trowel to get smooth finish.
STORAGE: All the components Resin, Hardener & Filler
must be kept in cool, dry place and in covered shed.
HEALTH & SAFETY: It is advisable
to wear protective wears at the time of use of
Epoxy Screed and all other our products. In case
of contact with eyes and skin, wash with plenty
of water and consut a doctor.
This information, given above in good faith, is
based on results gained from experience and tests.
However, all recommendations or suggestions are made
without guarantee since the conditions of use is
beyond our control.
|
