DESCRIPTION: Our epoxy coating based on high performance, high build, thoxotropic, chemical resistant epoxy resin base chemical resistant finish.

FEATURES:

• Being smooth, surface it is very easy to clean and to make it dust free.
• Product is based on high performance epoxy resin & curing. agent system The coating system has excellent overall chemical resistance at ambient temperature.
• Carefully selected resin & curing agents gives excellent abrasion resistance, good adhesion, easy cleaning .
• System is available in many attractive colors.

USES: Epoxy coating is highly recommended as protective coating mainly on concrete where chemical resistance is required, eg.

• Waste water treatment plant
• Tanks, silos, floors, dyke walls, in Food & pharmaceuticals Chemical & Engineering, Beverages, Textile & Pulp-Paper industries
• Textile & Pulp-Paper Industries.

SPECIFICATION:

Film Thickness	300-400 microns
Coverage	0.25 to 0.3 kg/M  per coat
Application	Brush, Roller
Curing	Initial-6-6-7 Hrs full 7 days
Finish	Gloss
Mixing Ratio	As directed on Packing
Colors	Grey, Green, Red, Black, White or as required

SURFACE PREPARATION : Successful performance of epoxy coating or any other flooring system can achieve only after proper surface preparation. It is the prime requirement, that surface must correctly prepared before application.

New concrete or cementations surface must be cured for 28 days.

Surface must be free from any oils, grease, loose particles, curing aid chemicals, previously applied coating etc...

Surface must be fully dry.

For old surface, all cracks, cavities should be repaired with EPOXY mortar.

This is a very thin topping so cannot level any irregularities of levels of the original sub-base. Therefore, it is most important to make original surface in line & level, before application of Epoxy coating.

APPLICATION

PRIMER COAT : Apply one coat of EPOXY COATING primer on properly prepared surface by brush and allow it to dry.

TOP COATS : First miz the resin part A, thoroughly with slow speed mixer until uniform color is achieved. Then add curing agent part B and mix with mixer until a homogeneous mass is achieved.
Apply by brush or roller on properly primed surface. Apply minimum two coats for best mechanical and chemical resistance properties. mechanical and chemical resistance properties. Recoating should be done only after 4-5 hours. when the first coat is joust touch dry. In case the first coat is cured hard, surface should be roughened by emery paper. Dust should be removed properly before application of 2nd coat.

STORAGE: All the components Resin, Hardener & Filler must be kept in cool, dry place and in covered shed.

HEALTH & SAFETY: It is advisable to wear protective wears at the time of use of Epoxy Coating and all other our products. In case of contact with eyes and skin, wash with plenty of water and consult a doctor.

This information, given above in good faith, is based on results gained from experience and tests. However, all recommendations or suggestions are made without guarantee since the conditions of use is beyond our control.