»  MORTARS FOR ACID PROOF BRICK / TILE / MAN DANA STONE
 
Furane Epoxy Mortar Phenolic Mortar
Vinyl Ester Mortar (VE) Epoxy (HYB) Mortar Sulfur (Hot Pour Type)
CNSL Mortar K. Silicate Mortar Mastic Compoand
Polyester Mortar A.R.Primer    

————————————————————————————————————————————————
A.R.PRIMER :-
——————————————————————————————————————
°
INTRODUCTION:

All type of surface whether, it is concrete, steel or wood, and require protection against corrosive environment. To protect substriate against corrosive attack, it is recommended to apply anti-corrosive primer followed by further finish coats, screed lining or brick/tile lining. A.R.Primer is most suitable primer to protect different type of sub-striate against atmospheric corrosion and chemical corrosion.

°
AREA OF APPLICATION:

A.R.Primer can be applied on variety of sub-striate like steel, concrete, wood. To protect steel structure, tanks,pipes, girders, marine structure either exteriors or interiors. A.R.Primer is very widely used on concrete as a primer where further acid resisting brick/tile lining is recommended.


° PHYSICAL PROPERTIES:

Viscosity @ 25 C by Ford cup
B4 in Sec.
90-120
Drying time @ 25 C. 1 hr
Bonding to steel/concrete/ceramic/MS GOOD
Shelf Life (in sealed container
only)
1 yr.


°
METHOD OF APPICATION:

Concrete should be sound, properly cured for min. 28 days, damp free, even in line, free from any loose cement mortar and any loose particles, before application of A.R.Primer and any type of further acid
resisting brick/tile lining installation.

°
APPLICATION:

1. The material in the container should be properly mixed before application.

2. A.R.Primer can be applied with good quality of painting brush in a uniform thickness. Consumption of material will depends on surface condition and absorption of the concrete. Two coats recommended for best
performance. Allow 2-3 hrs. Drying time between each coat.

3. On MS surface, sand blasting is recommended for good bonding with sub-striate, follow by two coats of A.R.Primer anti-corrosive primer.

°
CHEMICAL RESISTANCE PROPERTIES::

STORAGE:
A.R.Primer should be stored in properly sealed containers away from direct sun light, heat and flame. Reseal container after use.

PACKING:
25 Lts. 200 Lts. good quality MS container.

HEALTH & SAFETY:

It is advisable to wear protective wears at the time of use of A.R.Primer and all other our products. In case of contact with eyes, clean with plenty of water and consult a doctor. This information, given in good faith, is based on results gained from experience and tests. However, all recommendations or suggestions are made without guarantee since the conditions of use are beyond our control.