PHENOLIC
MORTAR :-
—————————————————————————————————————— |
° |
INTRODUCTION:
This is a two-pack chemical
setting Phenolic base mortar. It is being used as
bonding material for acid resisting brick masonry
construction for protection against corrosive
conditions mainly from acids, in more particular, its
resistance to Sulfuric acid upto 70 % is very good.
|
| ° |
AREA
OF APPLICATION:
Phenolic is used for acid resisting brick/tile lining
where protection against Sulfuric acid is needed. It
is recommended for pickling tank lining, reaction &
storage vessels lining, floors, drains lining.
|
| ° |
PHYSICAL PROPERTIES:
| Color |
Black |
| Mix Ratio by wt. Sol to Powder |
1:3 |
| Compressive Strength kg/cm2 |
150 |
| Flexural Strength kg/cm2 |
75 |
| Bond Strength kg/cm2 |
10 |
| Water Absorption |
1% |
| Max. Temp. |
150 C |
| Setting Time In Hours |
18-24 |
|
| ° |
METHOD
OF APPICATION: MIXING
phenolic is prepared by mixing solution & powder
to form a workable mortar. The recommended
ratio of mixing is 1 part solution to 3 parts powder
by wt. The ratio will vary depending upon ambient
temperature and working conditions. Use clean, dry
mixing pan. Take-out required quantity of solution
and add powder to it, slowly and start mixing until
you get smooth paste, free from loose powder. Do
not prepare more material, then can be used within
20-30 minutes.
|
| ° |
APPLICATION:
Phenolic mortar is buttered on clean, dry bricks or
tiles, which, kept at ambient temperature. Apply little
more material on center and place to avoid air pocketing
while installation. If only joints are to be filled
with phenolic, it is essential that full depth be filled
with mortar. During & after completion of the lying
of bricks or tiles, the area must be kept dry and free
from any other materials and traffic, which can affect
setting & curing of phenolic.
|
| ° |
CHEMICAL
RESISTANCE PROPERTIES::
phenolic can
provide very good protection against strong mineral
acids upto 70 % and oxidizing acids, organic and
fatty acids, oil, fats, and many solvents. phenolic "
C” 100 % carbon filled mortar is recommended to
protect against HF, fluoride salts etc.
|
| ° |
STORAGE & SAFETY:
Always keep solution& powder in cool
dry place in sealed container and bag, away from direct sunlight,
moisture. If stored
as above and in sealed container at 20 C, shelf life
of solution will be 3 months, and powder 6 months.
|
| ° |
PACKING:
Solution:
25 KGS & 225 KGS (net) ingood quality MS drums. Powder:
50 kgs (net) in
LDPE+HDPE bags.
|
| ° |
HEALTH & SAFETY:
It is advisable to wear protective wears at the time of
use of phenolic and all other our products. In ase of
contact with skin & eyes wash with plant, of water
and consult a doctor. This information, given above in
good faith, is based on results gained from experience
and tests. However, all recommendations or suggestions
are made without guarantee since the conditions of use
are beyond our control. |
