EPOXY
MORTAR (HYB) :-
—————————————————————————————————————— |
° |
INTRODUCTION:
This HYB mortar is versatile three (3)-component chemical
resistant hybrid EPOXY resin base mortar. The product
exhibits excellent bond strength, high chemical resistance
and reliable curing characteristics.
|
| ° |
AREAS
OF USE:
EPOXY HYB can be used in construction of acid resistant
screed & brick/tile linings to floors, drains, sumps,
tank farm areas, tanks & process vessels, waste
water treatment plants etc. and jointing mortar for
red Mandana stone flooring. It is the most suitable
for use in installation of acid resistant brick/tile
lined areas, which are very often subjected to concentrated
acids and alkaline conditions.
|
| ° |
OUTSTANDING
FEATURS:
1)Resistant to 90% Sulfuric acid conditions at
room temperature.
2)
Resistant to organic solvents
3)Resistant to Caustic Conditions & Hypo chlorite
solutions.
4)
Very low Shrinkage.
5)
Excellent bond strength to acid resistant
brick/tile/stone.
|
| ° |
METHOD
OF APPICATION MIXING:
Make sure that the contents of each
container are thoroughly mixed before use.
1. Pour measured quantity (One part by wt.) of part
A into clean, dry mixing container.
2. Add measured quantity of part B (0.6 part by
wt.) and mix thoroughly for one minute.
3. Add measured quantity of part C filler (5.5 parts
by wt.) a little at a time, mix slowly until the
filler is thoroughly wetted by the resin (Part A) &
Hardener (Part B) mix, to produce a
homogenous trowel able mortar.
4. Mortar, which has begun to set, cannot be
recovered by adding more resin. Such mortar
must be discarded.
5. Never add water and any other diluents.
|
| ° |
USE
INSTRUCTIONS:
EPOXY HYB mortar is applied by trowel to clean, dry,
neutralsurface with following procedures:
1) All bonding surface shall be buttered
completely without voids.
2) Mortar joints should be kept full, and
minimum 4mm wide.
3) Mortar may be applied directly over mastic
membrane surface and other membrane
surfaces including rubber and plastics.
4) Reducing the ration of filler in the mix shall
not lengthen the working & setting time of
mortar. These factors are best controlled by
temperature.
|
| ° |
CLEAN
UP:
Mixing & application tools shouldbe cleaned radically
using M.E.K., xylene or
toluene. Observe proper safety precautions
while cleaning.
|
| ° |
CURE TIME:
If the substrate
and ambient air
temperature in contact with the acid resistant
brick/tile construction are at 250 C allow a
minimum of 24 hours cure time before putting
the acid resistant brick/tile lining construction to
its intended service.
|
| ° |
STORAGE & SHELF
LIFE:
All the components Resin,
Hardener & Filler must be kept in cool, dry
place and in covered shed. |
| ° |
PACKING Solution:
Resin: 25 kegs and 200 kegs
Hardener 15 kegs Filler 50 kegs in
LDPE+HDPE bags.
|
| ° |
HEALTH & SAFETY:
It is advisable to wear protective wears at the time
of use of EPOXY HYB and all other our products. In case
of contact with eyes and skin, wash with plenty of water
and consult a doctor. This information, given above
in good faith, is based on results gained from experience
and tests. However, all recommendations or suggestions
are made without guarantee since the conditions of use
is beyond our control. |
| |
|
