epoxy coating based on high performance, high
build, thoxotropic, chemical resistant epoxy resin
base chemical resistant finish.
- Being smooth, surface it is very easy to clean and
to make it dust free.
- Product is based on high performance epoxy resin & curing.
agent system The coating system has excellent
overall chemical resistance at ambient temperature.
- Carefully selected resin & curing agents
gives excellent abrasion resistance, good adhesion,
- System is available in many attractive colors.
USES: Epoxy coating is highly
recommended as protective coating mainly on concrete
where chemical resistance is required, eg.
- Waste water treatment plant
- Tanks, silos, floors, dyke walls, in Food & pharmaceuticals
Chemical & Engineering, Beverages, Textile & Pulp-Paper
- Textile & Pulp-Paper Industries.
to 0.3 kg/M
full 7 days
directed on Packing
Green, Red, Black, White or as required
PREPARATION : Successful performance
of epoxy coating or any other flooring system
can achieve only after proper surface preparation.
It is the prime requirement, that surface must
correctly prepared before application.
New concrete or cementations surface must be cured
for 28 days.
Surface must be free from any oils, grease, loose
particles, curing aid chemicals, previously applied
Surface must be fully dry.
For old surface, all cracks, cavities should
be repaired with EPOXY mortar.
This is a very thin topping so cannot level any
irregularities of levels of the original sub-base.
Therefore, it is most important to make original
surface in line & level, before application
of Epoxy coating.
PRIMER COAT : Apply one coat
of EPOXY COATING primer on properly prepared surface
by brush and allow it to dry.
TOP COATS : First miz the resin part A, thoroughly
with slow speed mixer until uniform color is achieved.
Then add curing agent part B and mix with mixer until
a homogeneous mass is achieved.
Apply by brush or roller on properly primed surface.
Apply minimum two coats for best mechanical and chemical
resistance properties. mechanical and chemical resistance
properties. Recoating should be done only after 4-5
hours. when the first coat is joust touch dry. In
case the first coat is cured hard, surface should
be roughened by emery paper. Dust should be removed
properly before application of 2nd coat.
STORAGE: All the components Resin, Hardener & Filler
must be kept in cool, dry place and in covered shed.
HEALTH & SAFETY: It is advisable
to wear protective wears at the time of use of
Epoxy Coating and all other our products. In case
of contact with eyes and skin, wash with plenty
of water and consult a doctor.
This information, given above in good faith, is
based on results gained from experience and tests.
However, all recommendations or suggestions are made
without guarantee since the conditions of use is
beyond our control.