FURANE is a two-part chemical setting Furan base mortar
used for bonding acid resistant bricks and tiles. It
is impermeable in texture and resistant to a very wide
range of chemicals, including strong acids alkalis,
oils, solvents and unaffected by temperature upto 170
C. FURANE"C" a 100 % carbon filled mortar
is available where resistant to Hydrofluoric acid, fluoride
salts and strong hot alkalis are required.
AREA OF APPLICATION:
FURANE is used for acid resistant bricks and tiles lining
where maximum chemical resistance is required e.g. dyestuff,
rayon, steel, thermal power stations, fertilizers, petro-chemicals,
food-pharmaceuticals industries on locations like floors,
drains, tanks, reaction & storage vessels, effluent
treatment plants etc.
|Mix Ratio by wt. Sol to Powder
|Compressive Strength kg/cm2
|Flexural Strength kg/cm2
|Bond Strength kg/cm2
|Water Absorption kg/cm2
OF APPLICATION: MIXING:
FURANE is prepared by mixing solution & powder to
form a workable mortar. The recommended ratio of mixing
is 1 part solution to 3 parts powder by wt. The ratio
will vary depending upon ambient temperature and working
conditions. Use clean, dry mixing pan. Place appropriate
quantity of solution in mix pan, and add powder slowly,
mixing thoroughly until completely dispersed. Do not
mix more material, then can be used within 20-30 minutes.
Ensure that bricks or tiles are clean, dry and stored
at ambient temperature. Butter the bricks or tiles with
mixed mortar ensuring uniform coverage, with a slight
more in the center so no air pockets are formed while
its installation. When using as only jointing mortar,
it is essential that FURANE is filled to the full depth
joint. During and after completion of the
application, the area must be kept dry and free from
any other materials, which can affect setting and
curing of FURANE.
FURANE is recommended to use against very wide range
of acids, alkalis, solvents, salts, oils and fats. However
FURNAE is not recommended to use against HF, fluoride
salts, and strong hot alkalis. For these
conditions, FURANE"C" 100 % carbon filled
mortar is available. Also it is not recommended against
strong oxidizing acids like chromic acid, Nitric acid
and other oxidizing agents.
||STORAGE & SHELF
solution & powder in cool dry place in sealed
container and bag, away from direct sun light,
moisture etc. If stored as above, shelf life of
solution: 1 year powder: 3-4 months.
kegs and 250 kgs sound
quality MS drums. Powder: 37.5 kgs in
HEALTH & SAFETY:
It is advisable to wear protective wears at the time
of use of FURANE and all other our products.
In case of contact with eyes and skin, wash with plenty
of water and consult a doctor. This information, given
above in good faith, is based on results gained from
experience and tests. However, all recommendations or
suggestions are made without guarantee since the conditions
of use is beyond our control.